My Mahindra 3215 shuttle shift has very little power. Just about any resistance causes the wheels to stop. It doesn’t appear that the clutch is slipping. Anyone have any suggestions? I replaced the fuel filter and cleaned the air filter. The fluid levels are fine!
My Mahindra 3215 has very little power
- Thread starter Jimneaf
- Start date
- Views: 1539
-
- Tags
- mahindra 3215
mddorange
Elite Member
- Joined
- Jul 16, 2014
- Messages
- 3,357
- Location
- Guin, AL
- Tractor
- 2014 Kubota L3200 DT w/LA524 FEL, Loaded rear tires, LP RCR 1860 5' Cutter, LP RTA 1258 5' Tiller, LP PFL 2042 Pallet Forks w/60" Extensions, KK BB60 Box Blade, KK PHD-12" Post Hole Digger
:welcome:
To the TBN forum Jim.
What are the rpms when it stops? Does it start with normal rpms and them drop?
To the TBN forum Jim.
What are the rpms when it stops? Does it start with normal rpms and them drop?
3gunr
Veteran Member
- Joined
- Apr 17, 2018
- Messages
- 1,172
- Location
- wentzville mo
- Tractor
- mahindra 2538 mahindra 2810 cub cadet 7260 massey 255
Check the parking brake.Done that before.
TBN Support
TBN Support
- Joined
- Feb 4, 2015
- Messages
- 4,561
:welcome:
Welcome to the forum!
I'm going to move this thread over to our Mahindra section.
Welcome to the forum!
I'm going to move this thread over to our Mahindra section.
Gary Fowler
Super Star Member
- Joined
- Jun 23, 2008
- Messages
- 11,917
- Location
- Bismarck Arkansas
- Tractor
- 2009 Kubota RTV 900, 2009 Kubota B26 TLB & 2010 model LS P7010
Never heard a slipping clutch make any sound. For a gear drive, only one thing will allow the engine to maintain RPM but no forward motion. You need to get that clutch adjusted NOW before the slipping burns it up. Hopefully it is only an adjustment needed and not a new clutch plate. With a shuttle shift there is also a hydraulic clutch action that briefly depresses the clutch plate when the shuttle shift lever is moved, it could be that the hydraulic clutch is not disengaging correctly also. A trip to the dealer is recommended for this.
