Mpower 85 alarm

[Hayboy83]

I have an issue on my brothers mpower 85. My dad was using it to bale hay and an alarm went off but nothing on the control panel is lighting up. My brother and i are hay partners and he is in the Army and training in Fort Hood so I'm the man in charge of his stuff right now. The next day after baling hay, I ran the tractor and the alarm started going off about 15 minutes after starting. I am gonna take it in this week but I'm just wondering if any of y'all have seen this problem. Once again, tractor runs fine, nothing is lighting up on dash board, alarm is steady going off after 15 mins.

 

[Jabonee]

Low transmission PSI warning. Page 45 operators manual.

 

[Hayboy83]

Thank you sir, I add trans fluid, it was a little low. I don't have my manual in front of me. Do u know if there is a couple of things I could look for? Save me a trip to the dealer. I'm gonna take it home and change all the filters

 

[Navasot]

Scavenger pump sensor is bad... replace the sensor its like $6 if its out of warranty... its one wire plug that comes off then you screw it out the side of the transmission and put the new one it.... its right behind the battery on the top of the transmission sticking out sideways

 

[Navasot]

You will have to lay down under the cab and look up the side of the transmission to see it better

 

[Navasot]

Also be sure your filter is on well... we had one that was just loose enough to suck air through the filter.... my bet its 98%on the scavenger pump sensor

 

[Hayboy83]

Thank you, I'll try it

 

[Hayboy83]

Ok, quick update. First of all, thank y'all for the feedback! Still can't get my hands on manual, my brother and dad are both looking around for it. I did get under the tractor and seen a sensor behind the battery. I disconnected it and tried to start the tractor without it but tractor wouldn't start. So I connected it and while I was under there, I found another sensor that was disconnected. That one was under the rear axle. Before I connected it, I started the tractor and moved it so I could get down a mower I just bought. Then I connected the sensor and started unhooking the mower. And just like before, 15 minutes after start up I heard the alarm from outside of the tractor. I got back into the tractor and the 4x4 light on the dash board was on. I'm really don't have a lot of time operating this tractor so I never thought to look at that lever. So the I pressed the clutch and disengaged the 4x4 and as soon as I let the clutch go the alarm went silent. I'm gonna use the tractor to check my baler and mower, so I'll let y'all know if it comes back.

 

[Hayboy83]

Ok, the alarm came back after 15 min but went silent for 15 min. Then it came back on.

 

[Navasot]

Did you replace the scavenger pump sensor?