Mounting a Tilt Dump MCS on a JD445

   / Mounting a Tilt Dump MCS on a JD445 #1  

bjorn773

Silver Member
Joined
Mar 4, 2016
Messages
117
Location
Roscoe, IL
Tractor
Kubota L2250
I purchased a leaf collector yesterday on marketplace. The best I can tell is that it's the JD Tilt Dump MCS. This particular model has the gas engine off to the side to run the blower, not the pto driven blower. It was mounted on an X730 I believe, so the included brackets are not quite the same. I am hoping that I can mount it to my 3 point hitch by fabricating an adapter. Would there be any concern with that weight on the 3PH? I believe it's rated for 758#. Please advise and thank you!
 

Attachments

  • 1000015182.jpg
    1000015182.jpg
    5.6 MB · Views: 26
   / Mounting a Tilt Dump MCS on a JD445 #2  
Your L2250 should handle the weight just fine. If not, put a few suitcase weights on the front bumper.
 
   / Mounting a Tilt Dump MCS on a JD445 #3  
Your 445 should handle that but like big tiller states you may need some front weights when that bagger is full of wet grass or support caster wheels on the rear.
 
   / Mounting a Tilt Dump MCS on a JD445
  • Thread Starter
#4  
Your 445 should handle that but like big tiller states you may need some front weights when that bagger is full of wet grass or support caster wheels on the rear.
Thanks. It will be going on the JD445 as I don't have a mowing deck for the L2250. I've got 6 suitcase weights and a front weight bar, so should be good there.
 
 

Tractor & Equipment Auctions

NEW HOLLAND 706 30 INCH 3PT DIRT SCOOP (A53472)
NEW HOLLAND 706 30...
BESTWAY LOT IDENTIFIER 40 (A53084)
BESTWAY LOT...
2022 CATERPILLAR D4 LGP CRAWLER DOZER (A51246)
2022 CATERPILLAR...
2012 Nissan Maxima Sedan (A51694)
2012 Nissan Maxima...
PALLET OF ARMSTRONG CEILING TILES (A51248)
PALLET OF...
2001 Bobcat 337 Mini Excavator (A51573)
2001 Bobcat 337...
 
Top