Motor specs on the 48" T-8 brush cutter?

[KentT]

Anyone know what the specs are? Tried searching to no avail...

Mine is leaking at the shaft seal, after years of abuse and needs to be rebuilt or replaced. Likely could replace it from Surplus Center as cheaply as I could have it rebuilt. TIA...

 

[J_J]

If I recollect right, it was something like a 3 cuin motor.

With 8 GPM, speed = 616 rpm

---------------torque = 1432 in lbs or 119.3 ft lbs

Will develope about 14 HP.

Surplus Center

 

[KentT]

Thanks, JJ.

 

[duane]

Danfoss: 3 cubic inch per rev.