i recently purchased a kubota l5450 with a la1150 loader. the loader was not attached and the brackets that mount it to the fame near the floorboards are missing. thought it wouldn't be hard to get new brackets, which it's not if you're willing to pay kubota $3600, i am not. i have a competent fabricator willing to build them very reasonable but wants pics and measurements to go off. any help would be greatly appreciated
Loader missing loader brackets, need schematics
- Thread starter kbl5450
- Start date
- Views: 3883
mountaindog
New member
There is a craigslist post for some for a different loader. May fit, don't know, you will have to look up some part numbers. I don't know if I'm allowed to post links, but it is on the Albany NY craigslist under farm and garden posted on 1/5/12
GPintheMitten
Elite Member
- Joined
- Sep 8, 2009
- Messages
- 3,291
- Location
- Flushing, Michigan
- Tractor
- Kubota B2620 with BH65 backhoe, Ford 2N
If you have a Kubota dealer nearby and they have the same model, take some measurements and pictures.
alchemysa
Veteran Member
Theres a free parts diagram here. No dimensions but the pics might help.
Kubotabooks.com
Kubotabooks.com
carlav1410
Bronze Member
Hello
I was in same boat with Kubota with Loader sub frame.
I have posted a few pics of the sub frame my son and I built if you would like to take a look and get some ideas?
post is under LA350 loader today 1/7/12
Thanks Carl
I was in same boat with Kubota with Loader sub frame.
I have posted a few pics of the sub frame my son and I built if you would like to take a look and get some ideas?
post is under LA350 loader today 1/7/12
Thanks Carl
rbargeron
Elite Member
If I were making side frame brackets from scratch, I'd try to borrow a pair to use in duplicating them. The brackets have tapered tops the loader uprights fit over. There are wedges to hold each side and the bolts have stand-off spacers to the engine. It will be a challenging job without factory jigs and fixtures for lining everything up.
Attachments
Last edited:
rbargeron
Elite Member
There's a cross piece that connects the two side brackets and bolts to the bellhousing - shown in pic below. Also found a partial image of the left side bracket. Did they give you the flat bars that connect to the rear axle? (the ones in the pic are 3/4" thick for a backhoe subframe - the ones for just the loader are 1/2") How about the chin bar? Is there any way to track down the original parts?
