Billybob69
New member
Hey everyone....I borrow my buddies MF1235H regularly and so I do all the maintenance on it.
I picked it up yesterday and noticed a small puddle of oil on the right foot board. Traced it to the control valve
So I cut the zip tie and slide the boot back and found it dripping from the bottom edge. The face didn't seem like it was dripping anything fresh.
This is a 97 MF 1235H with the MF 1244 loader.
Am I looking at a huge rebuild or just a couple of o-rings?
Could it be as easy as removing these 3 screw and joystick and replacing a seal?
I can do most work...but haven't dug into this before. What should I look out for?
Thanks all!
I picked it up yesterday and noticed a small puddle of oil on the right foot board. Traced it to the control valve
So I cut the zip tie and slide the boot back and found it dripping from the bottom edge. The face didn't seem like it was dripping anything fresh.
This is a 97 MF 1235H with the MF 1244 loader.
Am I looking at a huge rebuild or just a couple of o-rings?
Could it be as easy as removing these 3 screw and joystick and replacing a seal?
I can do most work...but haven't dug into this before. What should I look out for?
Thanks all!
