MF30B Clutch Replacement

[Farris]

Hello all,

Farris here. First post so please bear with me...

I have a Massey Ferguson 30B loader tractor that needs a clutch. I've started splitting the tractor and my question is; can the loader be left on the tractor then split and roll the rear section back or will the loader have to come off? The tractor has a three point lift and PTO. No back hoe or roof. Also, will the entire dash/steering assembly have to be removed or can I leave the dash installed? Thanks in advance guys!

-farris

 

[Sportsman762]

If you have the 6x6 shuttle, or 8x2 transmission and a 32a or 34a loader you will most likely want to leave the loader attached to the front and roll it back from the rear. If you have a different loader it will most likely be easier to remove the loader. The dash can be left on the rear of the tractor, you will have to disconnect the steering lines and electrical. When rolling the rear back make sure the transmission is in neutral. If you have any questions let me know. I have a 20C, that is almost identical to the 30B (except the rear axle).