ziegler
Member
I just bought a 185 Backhoe to frame mount to my 65, but I have a Great Bend loader so I will have to get someone to-do some welding to frame mount.
Question:
1. What is the part # for the teeth and shank? Is there an equal after market replacement? Being I have to replace all teeth ans at least 1 shank, would I be better off switching to another design? The MF dealer is about an 1hr away but I have AGCO dealer closer.
2. Using it. Looks like all the picture so it be operated at an angle and not straight back. Is this because straight back would put too much load on the tractor and at an angle would but more of a load on the frame - side to side vs. font to back.
Question:
1. What is the part # for the teeth and shank? Is there an equal after market replacement? Being I have to replace all teeth ans at least 1 shank, would I be better off switching to another design? The MF dealer is about an 1hr away but I have AGCO dealer closer.
2. Using it. Looks like all the picture so it be operated at an angle and not straight back. Is this because straight back would put too much load on the tractor and at an angle would but more of a load on the frame - side to side vs. font to back.
