sliderbuck
Bronze Member
Has anyone found a replacement cylinder that will work for the curl on the loader? $450 a piece from Mahindra. Anyone know the specs on the stock cylinders?
Max26 curl cylinders
- Thread starter sliderbuck
- Start date
- Views: 4633
LittleBill21
Elite Member
how did you break it?
Pontific8
New member
Check out Magister Hydraulics cylinders on Amazon. I am very happy with my reasonably priced larger bore (slower action speed/more power) "replacement" curl cylinders for my 1526. I have been carefully enjoying success with stressful back blading, Ratchet Raking, etc, the last 2+ years -- Verboten, per most scut FEL manufacturers! As the cylinders are made in Ukraine, there may be supply problems due to the war...good luck.
OP
sliderbuck
Bronze Member
Happen to have a part number for them?
Pontific8
New member
Not for your 26XL...check out Amazon for a good manufacturer video on measuring for the Double Acting Hydraulic Cylinder you need.
OP
sliderbuck
Bronze Member
Seems like i read somewhere that the 1526 cylinders will work on the max26 though. Which ones did you buy from amazon? Curious what the specs is on them.
LD1
Epic Contributor
Why are they needing replaced?
mike69440
Elite Member
- Joined
- Jun 2, 2005
- Messages
- 3,297
- Location
- Central NH (God's Country)
- Tractor
- 2005 L39 Kubota, 2020 Polaris 570 Sportsman, 2006 RTV 900, 2019 RTV1100C, 1997 Komatsu PC75UU2E w/ Thumb & Blade, 2013 Mahindra Max28XL Shuttle plus many attachments
I had a difficult finding cylinders that fit well but exact fit, Do not go larger than 1.75 Piston. I used the 1526 cylinders and made an internal stop.
Weak Loader Curl Possible Solution For the Max28
There is a possible solution for the weak curl of the Loader. First off, the 1400Lb Lift at the pins just is not honest. The Loader manual states that the 1402 Lbs lift at the pins is developed at 2175 PSI System Pressure, 100 PSI more than what the relief valve is actually set at. I read that...
www.tractorbynet.com
Last edited:
OP
sliderbuck
Bronze Member
Well finally got it back up and working. Used the cylinders below. Had to open up the holes some for the pins. Holes was for .75” pins. Mine are .885 diameter. Other than that went right in. Had to find fittings to go from the cylinders to the hoses. Local place had them. Cheaper alternative to stock replacements which cant be found anywhere right now.
LD1
Epic Contributor
Still never answered as to why they were needing replaced?
