Hi all, I have a max 26 with the three cylinder Mitsubishi motor. After last winter I definitely want to install a block heater. Has anyone done this? I'm looking for a part number and an area to install... Pictures get bonus points! Lol. Tia
Max 26 block heater installation?
- Thread starter ray299
- Start date
- Views: 870
-
- Tags
- block heater max 26
doneill127
Gold Member
I have looked at this before and there are a couple of suppliers that say they make them to fit in one of the rear freeze plugs but never pulled the trigger. Mahindra has them but very expensive.
After I changed the way I start the tractor, I get pretty smooth starts even when it’s cold so I stopped my search. My tractor has the same engine as you.
After I changed the way I start the tractor, I get pretty smooth starts even when it’s cold so I stopped my search. My tractor has the same engine as you.
Not sure what will happen in the cold weather now, but I just put new cable clamps on and cleaned the ground. Starts much easier now... maybe that was the issue....? How did you change the way you started yours?
doneill127
Gold Member
Also check the connection to the glow plug buss bar Known issue with these. There are a number of threads on this. Check voltage on the buss to make sure you’re get around 10 volts when the plugs are on . I replaced mine with a ring terminal.
The Mahnindra manual say to put the throttle at idle hit the glow plug and start. The MHI manual (oem) says to crank throttle wide open, hit the plugs start the engine and throttle down. Below is a thread on it.
www.tractorbynet.com
The Mahnindra manual say to put the throttle at idle hit the glow plug and start. The MHI manual (oem) says to crank throttle wide open, hit the plugs start the engine and throttle down. Below is a thread on it.
Cold engine starting procedure
Just curious. My Max has an MHI SL3 diesel with Bosch Denso Injection. The Mahindra manual says the starting procedure is to put speed control at idle, hit the glow plugs (10 sec), then start the engine, cold or hot. The Mitsubishi SL3 Operation/Maitenance manual says the cold engine start...
www.tractorbynet.com
