Mantis 2-cycle rotor tiller priming bulb problem

[jayhawk238]

The priming bulb on my tiller is not working right. When I push the bulb and then release it takes over a full minute to recover and it appears it is not drawing and fuel. Which, of course will not allow me to start the tiller. Any ideas on how to fix this problem?

 

[Barry 1]

You could try to take the carb apart and clean it ,but the plastic primer pump can't be taken apart.I just tossed mine and bought a new one off Ebay ($10)

 

[Clay45]

Does it look anything like this ?

Primer Assembly [22135-816] for Shindaiwa Lawn Equipment | eReplacement Parts

 

[ProjectKing]

You need to replace with new one. You can buy online. Just search around. Fairly common part. Mantis uses Echo 2 stroke engines. A local small engine shop or power equipment dealer should also be easily able to get part.

 

[jayhawk238]

No, mine is different. On mine you remove our screws that holds a cover over the bulb. But thaks for the try.

Does it look anything like this ?

Primer Assembly [22135-816] for Shindaiwa Lawn Equipment | eReplacement Parts

 

[jayhawk238]

Thanks! I'll go to Ebay and look for one.

 

[jayhawk238]

Thanks! That sounds like the way to go.

 

[mopardude318]

i have had several of those mantis tillers. they sure are useful little guys.

 

[Clay45]

P00500-3120

Primer Bulb | Mantis Garden Tools

 

[jayhawk238]

Thanks Clay!