LT150, installing Briggs & Stratton EX1900

[austyncopley]

Looking to get some advice installing new motor on my 2002 LT150.
Family member purchased a brand new 19hp EX1900 but did not receive any installation instructions.
Previous motor had 2 wire plug, red and white, while new engine has grey black red and orange.
I've spent a couple hours tracing wires and testing with my voltmeter, but unable to figure out how to properly wire the new motor.

Thank you for your time

 

[airbiscuit]

Wiring Loom Connections for Briggs & Stratton Ride On Mower Models

If you are replacing your ride on mower engine with one of the new Briggs & Stratton Single Cylinder Ride on Mower Series Models, the wiring loom and connector might be slightly different to your old model, depending on what brand of ride on mower you have. Your mower will have a starter motor...

www.smallenginewarehouse.com.au

 

[airbiscuit]

We have listed below, the wires found on the new Briggs & Stratton single cylinder engines and where they need to be connected to.

RED WIRE - This is your DC cable, it should be connected directly to positive power on your battery. This wire charges your battery.

BLACK WIRE - This is the engine kill switch, It needs to run to an ON/OFF switch and then run to earth. DO NOT CONNECT THIS WIRE TO POSITIVE POWER!

GREY WIRE - This needs to run to an on/off switch and then to positive power on your battery, this controls the carby solenoid for fuel.

ORANGE WIRE (IF FITTED) - Can be connected to headlights or any other accessories

 

[airbiscuit]

Did that help?

 

[gstrom99]

crickets... I hate that.

 

[airbiscuit]

It happens too often. Someone asks for help and gets lots of responses, but never lets us know what worked. That's not helpful for the next person with the same problem.