Lights on a Case ROPS

/ Lights on a Case ROPS #1  

MrJoe

Silver Member
Joined
May 7, 2004
Messages
117
Location
Southbury, Conn.
Tractor
Case IH DX24E
Good Day: One unexpected side benefit of my Case DX24E has been the ease of mounting lights to the ROPS. It has four 3/8" holes factory drilled front to back on the top of the ROPS. I just took perforated angle iron, bolted it to the top, added a light to a switched wire to the under seat aux. plug /forums/images/graemlins/smile.gif
Like most of you I needed more light but did not want to drill or weld to the ROPS /forums/images/graemlins/frown.gif The factory did if for me /forums/images/graemlins/smirk.gif
 
/ Lights on a Case ROPS #2  
</font><font color="blue" class="small">( Good Day: One unexpected side benefit of my Case DX24E has been the ease of mounting lights to the ROPS. It has four 3/8" holes factory drilled front to back on the top of the ROPS. I just took perforated angle iron, bolted it to the top, added a light to a switched wire to the under seat aux. plug /forums/images/graemlins/smile.gif
Like most of you I needed more light but did not want to drill or weld to the ROPS /forums/images/graemlins/frown.gif The factory did if for me /forums/images/graemlins/smirk.gif
)</font>

How many lights did you install?
Can you pivot them up and down?
Can you rotate them 360 degrees.
Can you illuminate all the way around the tractor with them?
 
/ Lights on a Case ROPS
  • Thread Starter
#3  
I just put one on the bracket, thought I would see if that was enough. So far it is. I bought a cheapie trapozidal pattern light from Auto Zone($10). The pattern is Ok but I think I'll try a flood next.
I can adjust the light up and down, side to side, backward, it's on a ball mount bolted thru the perforated angle. Has to be shifted by hand each time but 95% of the time it's looking ahead. There is enough amps left (w/v=a) in the aux. plug (10a.) to run another light so I might try that.
The whole setup cost about $25 by the time I was done. Switched plug wire from Radio Shack, light from Auto Zone, perforated angle and bolts from Home Depot.
I suspect the ROPS holes are for mounting a canopeas /forums/images/graemlins/wink.gif on top but it does what I want for now.
 

Marketplace Items

2016 Ford Escape SUV (A66738)
2016 Ford Escape...
2014 Forest River XLR Thunderbolt 40X12HP 40ft. Tri Axle 5th Wheel Toy Hauler Travel Trailer (A66738)
2014 Forest River...
PORTA POTTY (A68842)
PORTA POTTY (A68842)
2019 Chevrolet Tahoe SUV (A66738)
2019 Chevrolet...
Stertil Koni 18000lbs 4-Post Auto Lift (A61572)
Stertil Koni...
2019 Ford F-150 Ext. Cab Pickup Truck (A66736)
2019 Ford F-150...
 
Top