DavidS
Member
how do you guys stand up your finish mower to work on the underside?
lifting finish mower
- Thread starter DavidS
- Start date
- Views: 719
tdenny
Platinum Member
Most guys I've seen out here who use something other than the 3 point lift use a chain and do it with the FEL. I just raise my 3PH up as far as it will go and get down low and spray away. Yep I tend to get a little wet while doing this. /forums/images/graemlins/grin.gif Hey it's summer time anyway. Good luck
fivestring
Veteran Member
I read a reply here from one guy that installed an eye bolt to the back of the mower. He attached a chain to the eye bolt and the other end to a beam or rafter. He would disconnect the top link (leaving only the 2 lower arms connected), raise the 3ph and pull the chain, thereby lifting the front and back of the mower. Hope I explained it to where you could understand it.
