Landpride RCR1872 Slip Clutch Disks Help!

[wirlybird]

Just picked up a used 1872 cutter and I need the disks for the slip clutch. The cutter is using PTO shaft 826-656C and disk part number 180.015.019 (comer)
I found them at Messicks for $50+ anyone have a place to get these at a better price? Every dollar saved helps!
I am looking but so far no real luck.
Maybe a cross reference?

Thanks!

 

[Eagle1]

https://www.lindstromequipment.com/...1-l40nEeMvyPqHHdpLkvKyAUcENOa9EnRV.YpmOmQalk8

$38.10

 

[wirlybird]

Thanks, I thought I had looked at them and seen $62 but I must have messed up!

 

[wirlybird]

Great Plains 180.015.019 COMER LINING RIN

$38.10

Was just going to order from them until I found they wanted $25 to ship the two disks.
The disks are 5.5 inches in diameter and an 1/8 inch thick.

 

[Eagle1]

Was just going to order from them until I found they wanted $25 to ship the two disks.
The disks are 5.5 inches in diameter and an 1/8 inch thick.

Sorry did not go that far to find out. Shipping can really tick me off...

 

[wirlybird]

Sorry did not go that far to find out. Shipping can really tick me off...

No worries! They had a good price, compared to others, but crazy shipping ... AND you can get free shipping if you spend $1000!

I decided to look for disks by size and found a couple at Quality Farm Supply that are the correct sizes for $6.50 each and $15 shipping.
They might be slightly thicker, I'll need to check, but that is not a big deal. Mine are probably worn anyway.
Theirs are 0.12 inch thick and mine measures 0.118. It's just going to be used on a 60 or 72 inch brush hog so as long as it fits ok I think it will be fine.
At $6.50 each I can burn up a few!

 

[Sportsman762]

found a couple at Quality Farm Supply that are the correct sizes

What were the part numbers? It would be great if you could post them as then anyone else looking for the 826-656C slip clutch discs will know what to order.
Thanks!