L2500DT won't roll over

   / L2500DT won't roll over #1  

carlav1410

Bronze Member
Joined
Jan 22, 2009
Messages
55
Location
Mt Airy NC
Tractor
Kubota L2500DT 4X4
Hello all,
I have a 2000 L2500DT that won't roll over?
I have good lights,glow plugs heat up all safety switches are by pasted.
I have good voltage at starter.

Wondering if it could be the key switch causing my trouble?

Thanks to all
 
   / L2500DT won't roll over #2  
I was going to ask how big a hill you were trying to roll it over on. :laughing:

Is there any sound from the starter? Clicks or groans?

You are sure the seat or clutch safety switches are not causing the issue? If everything is by-passed and there is no sound at all from the starter, perhaps it has gone out?
 
   / L2500DT won't roll over #3  
Hello all,
I have a 2000 L2500DT that won't roll over?
I have good lights,glow plugs heat up all safety switches are by pasted.
I have good voltage at starter.

Wondering if it could be the key switch causing my trouble?

Thanks to all

If you can hot wire it successfully, then it's time for a new switch. Or you could do a quick continuity test to confirm your suspicion.
 
   / L2500DT won't roll over
  • Thread Starter
#4  
Thanks for all your replies I'm going to test out the starter today.
I'm also going to check the key switch out to see if there is any voltage when the key is in the start position?

Thanks Again Carl
 
   / L2500DT won't roll over
  • Thread Starter
#5  
Back again,

I tested the starter and key switch have 12 volts at key switch went turned to start.
If i jump starter from large to small terminal tractor rolls over.

I'm thinking problem might be in wiring harness ?
Anyone have ideas?

Thanks Carl
 
   / L2500DT won't roll over #6  
Most likely a failed safety switch. Bypass one at a time until you have joy.
Mike
 
   / L2500DT won't roll over
  • Thread Starter
#7  
Thanks to all,

I found the trouble.:D It was the arm on the neutral safety switch not pushing the pin on switch far enough in to make connection.....:confused2::confused: only wasted 4 hrs on it.:mad:

Again Thanks to ALL for the awesome advice Carl
 
   / L2500DT won't roll over #8  
My transfer case lever , must be wiggled sometimes to make it crank> Just a Tip?
 
   / L2500DT won't roll over #9  
After adjusting free clutch travel on my L225DT, I had the same problem. Had to glue a metal block on the clutch rod to complete circuit. Took me a while to figure that out.
 

Tractor & Equipment Auctions

2019 Ford F-550 Bucket Truck (A51039)
2019 Ford F-550...
LINDE H70 FORKLIFT (A50854)
LINDE H70 FORKLIFT...
2012 Vermeer V500LEHD Vacuum T/A Towable Trailer (A49461)
2012 Vermeer...
2015 FORD F-150 (A50854)
2015 FORD F-150...
2017 JLG Skytrak 6036 6,000LB 4x4 Rough Terrain Telehandler (A50322)
2017 JLG Skytrak...
2011 CATERPILLAR D9T HI-TRACK CRAWLER DOZER (A51242)
2011 CATERPILLAR...
 
Top