Kubota L3130

[dgage2]

The Intellipanel service inspect light will not reset, even though the hours do. Is there another way to get the light to reset?

Dick

 

[TripleR]

I am guessing you are trying this as per manual and holding both buttons down?

 

[dgage2]

Yes. In the past, this worked. But, now, nothing happens.

 

[moship]

Make certain it is in the Hour Meter display before pressing the two buttons to reset.

Per the IntelliPanel glossy that came with the tractor.

 

[TripleR]

Yes. In the past, this worked. But, now, nothing happens.

Mine did the same thing this week. I didn't want to hunt my glasses down, so I just rotated through a combination of all the settings holding both buttons down each and it went off.

My Operator Manual says to press the switch to traveling mode then press both down for two seconds.

 

[dgage2]

I did this per panel sheet, but it does not shut light off. Thanks

 

[TripleR]

I did this per panel sheet, but it does not shut light off. Thanks

Did you try all settings? Mine didn't shut off the first couple of times either until I tried all settings a couple of times; first time I ever had it happen.

 

[dgage2]

I will try it again, going through all settings a couple times, to see if it will work. Thanks for your advice.

 

[dgage2]

I will try it again, going through all settings a couple times, to see if it will work. Thanks for your advice.

I finally got back to our property, and the sequence you suggested did work on the second try of going through all of the settings and doing the reset. Thanks for sharing your knowledge.

Dick

 

[TripleR]

I finally got back to our property, and the sequence you suggested did work on the second try of going through all of the settings and doing the reset. Thanks for sharing your knowledge.

Dick

Glad to hear it worked for you, mine has only done that once and I have absolutely no idea why.