Kubota L2800 fuel solenoid connector.

[Boatman62]

I need to replace the connector that attaches to the fuel solenoid. Really only need the pins but will buy the whole unit if needed. Below is a link to the connector I need but it's too pricey and I don't know if it comes with the pins. I checkers the parts give and only found it as part of the witing harness. Any suggestions???

1C6583 Kubota - Connector - 2 way | Omega Parts International BV

 

[teg]

Can you just solder the wires together and use heat tape over the top?

 

[Redlands Okie]

So will new terminals work ? Just the clips. Not use the rubber casing that Locks in. Could cause a different problem with not locking in i guess.

Disconnects


| Fastenal

 

[Boatman62]

Can you just solder the wires together and use heat tape over the top?

This connector plugs directly onto the solenoid. If it were a matter of just 2 wires that needed to be joined I would do as you suggest.

 

[Boatman62]

So will new terminals work ? Just the clips. Not use the rubber casing that Locks in. Could cause a different problem with not locking in i guess.

Disconnects


| Fastenal

That won't really work in this case. Plus none of those are small enough. The male spades on the solenoid are only about 1/16" wide.

 

[Redlands Okie]

Well darn. I have heard of several in the forum talking about salvage places for Kubota tractors. Might do some looking for one of those or perhaps someone has a link