Mcfclz
New member
What is the proper procedure for connecting on board hydraulics to FEL and BH on kubota 7200
Kubota 7200
- Thread starter Mcfclz
- Start date
- Views: 1644
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,973
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Do you have a manual for your tractor?
I looked up data for a B7200 if that is what you have.
It does have a hyd block.
That is where you connect the loader
I looked up data for a B7200 if that is what you have.
It does have a hyd block.
That is where you connect the loader
mddorange
Elite Member
- Joined
- Jul 16, 2014
- Messages
- 3,357
- Location
- Guin, AL
- Tractor
- 2014 Kubota L3200 DT w/LA524 FEL, Loaded rear tires, LP RCR 1860 5' Cutter, LP RTA 1258 5' Tiller, LP PFL 2042 Pallet Forks w/60" Extensions, KK BB60 Box Blade, KK PHD-12" Post Hole Digger
:welcome:
To the forum from Alabama.
To the forum from Alabama.
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,973
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
No, you will use the fluid in the tank after you fill all the lines and cyl.
Once you operate the loader, and bleed all the air, just replenish the tank fluid.
Once you operate the loader, and bleed all the air, just replenish the tank fluid.
