John Deere 3038e/Wood splitter

[needsmoretractor]

I just ordered a new John Deere 3038e. I had the extra SCV added, but my understanding is they will not allow me to run a continuous flow to a three point wood splitter. This model does not have a power beyond kit. Is there a way to make this work, or do I need to by a pump for the PTO? Thank you

 

[J_J]

According to Tractordata, you have this.

Hydraulics:
Type: open center
Capacity: 5.5 gal [20.8 L]
Pressure: 2500 psi [172.4 bar]
Valve flow: 5.3 gpm [20.1 lpm]
Total flow: 9.3 gpm [35.2 lpm]
Steering flow: 4.0 gpm [15.1 lpm]
Steering press.: 1500 psi [103.4 bar]

Should be enough to run a splitter.

 

[needsmoretractor]

Thanks JJ. I guess i will have to look at the tractor closer once I get it. I know the ports listed are for the loader. I added two more, but the dealer said they would not allow for a live hydraulic feed to the splitter. In the manual is stated they should not be forced open. Hard to understand without the actual tractor in front of me though. Thanks again.

 

[J_J]

I would find out from the dealer why you can not keep a hyd valve open.

You should be able to take pump flow and direct it to where you need it.

What is the purpose of your SCV?

Purpose of an SCV is to re-direct fluid for a specific function,

Look at this link.

http://salesmanual.deere.com/sales/...e/loaders/hydraulics/740_controls_valves.html

What does the output of the SCV go?