Jinma Model 6 Bed Blade

   / Jinma Model 6 Bed Blade #1  

VaGlock

New member
Joined
Aug 5, 2020
Messages
23
Location
Roanoke, Va.
Tractor
Kubota B2601
I purchased a new bed blade (anvil) for my model 6 Jinma chipper and the new blade has one beveled edge, the original has 2 flat edges. Contacted the seller and he stated to install beveled edge towards the chipper blades. Has anyone run into this before?


20250314_123656 (1).jpg








 
   / Jinma Model 6 Bed Blade #2  
It is obvious that the new blade you bought is not compatible with JINMA 6'' chipper. As a fixed blade, normally both sides of it are flat and can be replaced and used interchangeably.
 
   / Jinma Model 6 Bed Blade
  • Thread Starter
#3  
I went ahead and installed it as Circle G Tractor Parts instructed me with the tapered side towards the rotating blades, set the gap to specs, They assured me it was the correct bed blade. After running some 2-3 inch branches through the chipper I was not pleased with the way it chipped, turned the blade around with the flat side towards the rotating blades and it chips a lot better. The original bed blade was broken and had to be replaced, so I just figured this was a updated blade. I know now that they sold me the wrong part even though it did fit.
 
 

Tractor & Equipment Auctions

2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2022 CATERPILLAR 259D3 SKID STEER (A51242)
2022 CATERPILLAR...
John Deere 1025R Tractor (A50514)
John Deere 1025R...
Hyster H155XL Forklift (A48837)
Hyster H155XL...
2021 Toyota Tacoma 4x4 Crew Cab Pickup Truck (A50323)
2021 Toyota Tacoma...
2022 Case TR340B Skidloader (RIDE AND DRIVE) (A50774)
2022 Case TR340B...
 
Top