Hiawatha22
New member
I bought a 347 baler used. Fist square I have ever owned and going through it now and getting it field ready and it needs a ton of work. A couple questions.
On the pickup should the follower bearing that fits into the yokes of the spider, fit in the spider tight or should there be some play? Right now I can grab all the angle iron bars and wiggle them. Spider yoke holes wore bad or is this the way it is supposed to be?
On the hitch there is a little coupler where the pin goes through. Is this supposed to move/wobble within the hole or is it to be solid? Doesn't seem to move right now but not sure if thats the way its supposed to be or is it ceased that bad?
So far all other questions have been answered by technical/owners/parts catalogue. She is a mechanics special ha ha. Any help appreciated.
On the pickup should the follower bearing that fits into the yokes of the spider, fit in the spider tight or should there be some play? Right now I can grab all the angle iron bars and wiggle them. Spider yoke holes wore bad or is this the way it is supposed to be?
On the hitch there is a little coupler where the pin goes through. Is this supposed to move/wobble within the hole or is it to be solid? Doesn't seem to move right now but not sure if thats the way its supposed to be or is it ceased that bad?
So far all other questions have been answered by technical/owners/parts catalogue. She is a mechanics special ha ha. Any help appreciated.
