JD 2520 POWER BEYOND

YASH2520 · Jul 18, 2006

I have just installed a power beyond kit on a JD 2520 compact tractor. I just want to verify which port would be the pressure port and which would be the tank port??

Based on the sticker, it looks like the top (female coupler) would be the pressure port.

Any insite would be greatly appretiated,

slowrev · Jul 18, 2006

If this is for a two way cylinder setup then both ports are pressure. They just swap from pressure to dump as you change directions on the flow.

JasonL · Jul 18, 2006

On my 4110 the top (female) connector is the out or pressure side. You probably know you must always keep the loop completed. If you aren't using a backhoe or other attachment, the connector hose must be used! Jason

Welcome to TBN! You will find a lot of helpful advice here!

YASH2520 · Jul 18, 2006

Thanks for the replies.

I know that if using a two way cylinder it does not really matter, but being in industrial maintenance I have learned from experience that it is better to have all the fitting connected as intended, less errors latter.