JD 2520 POWER BEYOND

[YASH2520]

I have just installed a power beyond kit on a JD 2520 compact tractor. I just want to verify which port would be the pressure port and which would be the tank port??

Based on the sticker, it looks like the top (female coupler) would be the pressure port.

Any insite would be greatly appretiated,

 

[slowrev]

If this is for a two way cylinder setup then both ports are pressure. They just swap from pressure to dump as you change directions on the flow.

 

[JasonL]

On my 4110 the top (female) connector is the out or pressure side. You probably know you must always keep the loop completed. If you aren't using a backhoe or other attachment, the connector hose must be used! Jason

Welcome to TBN! You will find a lot of helpful advice here!

 

[YASH2520]

Thanks for the replies.

I know that if using a two way cylinder it does not really matter, but being in industrial maintenance I have learned from experience that it is better to have all the fitting connected as intended, less errors latter.

 

[rockyridgefarm]

the female is the pressure port.

 

[jmt1271]

the female is the pressure port.

you can say that again!