Backhoe JD 110 LTB, 2003

   / JD 110 LTB, 2003 #1  

watco

New member
Joined
Nov 26, 2012
Messages
2
Location
Woodstock, VA
Tractor
JD110 TLB
I have a flashing light, code "long short, long short" Creep Control... engine speed sensor replaced, potent adj for creep control, potent for throttle control adj, all connection that can be serviced has dilectric grease installed, all filters changed and fluid... light comes on even if you let tractor warm up, then the creep wont work! the temp gage for the hydaulics doesnt seem to work (think maybe). some times tractor will go days with no flashing light! Help with any suggestions!!!
 
   / JD 110 LTB, 2003 #2  
Lets try to get some more info. what is the serial # of your tractor, the electrical changed through the years of the TlB 110.
Do you have a service manual?
Does the machine run ok if you are using the forward and reverse foot control?
Do I understand correct, you replaced engine sensor,creep control pot,throttle pot.
There are a few TLB 110 owner on here and they have helped me in the past, I am sure if we can get the facts we will be able to give you ideas to help you.
 
   / JD 110 LTB, 2003
  • Thread Starter
#3  
Lets try to get some more info. what is the serial # of your tractor, the electrical changed through the years of the TlB 110. (2003)
Do you have a service manual? (yes)
Does the machine run ok if you are using the forward and reverse foot control? (yes)
Do I understand correct, you replaced engine sensor, (adjust) creep control pot, (adjust) throttle pot.
There are a few TLB 110 owner on here and they have helped me in the past, I am sure if we can get the facts we will be able to give you ideas to help you.

year 2003
service manual, yes.
runs fine
replaced engine speed sensor, adjust creep pot, adjust throttle pot.
 
   / JD 110 LTB, 2003 #4  
The creep pot is connector X29, I believe pin A (black 550wire)is ground, C(orange 679wire) is supply and B(white 689wire) is the signal back to the HST controller pin J3. I would first check the connectors and wires. Since the machine runs with foot control the output for forward and reverse are ok. The inputs are what is left, could be the supply but this supply is shared with the other pots. Ground is the same.

X29 connector and wires.
HST controller white wire on J3.
HST controller.
The above are possible.

Is it possible you are doing something different when using the creep than normal. maybe seat switch.....other switches safety.

Sorry I just noticed you are new here, welcome to TBN. JD green tractor.gif
 

Tractor & Equipment Auctions

Chevrolet Silverado Pickup Truck Bed (A49461)
Chevrolet...
2006 KOMATSU D41P-6 CRAWLER DOZER (A51222)
2006 KOMATSU...
2014 STEPHENS 200BBL TANKER TRAILER (A50854)
2014 STEPHENS...
AC CHARGING MACHINE (A50854)
AC CHARGING...
2015 KUBOTA 1140CRX RTV (A51406)
2015 KUBOTA...
2014 UTILITY 53X102 DRY VAN TRAILER (A50046)
2014 UTILITY...
 
Top