sixdogs
Super Star Member
- Joined
- Dec 8, 2007
- Messages
- 13,266
- Location
- Ohio
- Tractor
- Kubota M7040, Kubota MX5100, Deere 790 TLB, Farmall Super C
The handle let go on my wife's turkey roaster pan today on a ham. The wire handle was just spot welded into the pan and then ceramic coated. I could easily clean that up and just tack the handle back into the pan but the wife isn't sure it would then be safe to eat out of. I don't see any problem since it was welded once so why not again? Just a simple MIG weld but no ceramic coating over it.
You guys know more than I do so any advice on this? Photos below.
You guys know more than I do so any advice on this? Photos below.