A dealer recommended that I not put a front end loader on a Ford 4000 because he said the front end of the 4000 was too weak - that it would work well for a while, but that enventually the load stress would would cause me to lose the front end. Is this true? Any advice or comments out there?
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,143
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
Unless your 4000 is a 4 cylinder 4000 (1962-1964) or a 4000SU model, your dealer is nuts. A 4000 3 cylinder All Purpose model has as strong a front axle as just about any 50 hp tractor of its time, or pretty much any other time.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Ditto what rick said... the later 3 cyl models from 65+ 4000 had a much better axle design than the older 4 cyl models that had the radius rods.
which 4000 are we talking about?
soundguy
which 4000 are we talking about?
soundguy
