international 47 square baler

[creek side cattle]

I just bought a little 47 international baler and found the needles on it have just the tip broke off does anyone know where I can order parts for this thing from

 

[Cowpaddy52]

If the eyes on the end aren't broken out you can braze the ends and grind them back to original contour.
Just make sure that you get them put back on the needle cradle properly and recheck the timing of the baler. I
think that the needle on the early 430 & 435 balers are the same. hope this helps.

 

[ham]

I had a 37. Interestingly nearly all the series of those balers are interchangeable. If you don't have anybody around that that collects them then just go to a Case IH dealer as they still carry them...though they are a bit pricey.