Hydro help

[careyo63]

If it was mine I believe that putting the plow back on it. Get it working again and then get a setup to remove it. I'm Org. from WV. Oh. and Md. actually 20miles from Pa. and It sure comes in handy. LOL.

 

[alpinebigfoot]

I will be putting it back on if this loop doesn't work. I need it off for the summer it gets stuck on everything because the underbelly sits so low.

 

[careyo63]

The loop will work. Do it like California posted. But point being you should be able to just put the plow back and get it working. Then take a breath and get Hyd. line made LOL.

 

[alpinebigfoot]

I hear ya thanks again

 

[Xfaxman]

Don't need to put it on, just park where the hoses will connect and try the 3 point. :thumbsup:

Don't even need to angle the blade, just plug the hoses in.

 

[alpinebigfoot]

The tractor should be fine running right with out being connected ?

 

[winston1]

All you need to do is connect the end of the two hoses together. Loop completed. Someone plumbed it so you could do that when removeing the blower.

The 186 parts manual does not show a key under the hex drive but Hoye shows a key for it. I would remove the nut and hex drive and take a look for a key.

 

[winston1]

All you need to do is connect the end of the two hoses together. Loop completed. Someone plumbed it so you could do that when removing the blower.

The 186 parts manual does not show a key under the hex drive but Hoye shows a key for it. I would remove the nut and hex drive and take a look for a key, sheared maybe. HYD. PUMP SHAFT KEY_: Yanmar Tractor Parts

 

[alpinebigfoot]

Ah **** I put it back in already. I guess if this loop does not work I will take it back out and do that. I will order the key just to have one Incase.

 

[winston1]

Did you understand plugging the two ends of your existing hoses together completes the loop?