Hydro control peddle...

[gravelman]

Hi folks...gravelman here..i have a 2015 Kubota 2650 the hydro peddle is not returning to neutral without bringing it there with the foot... i do not believe it is a lubrication problem as most of the linkage is free etc. I guess there are springs in there ?? before i go to dealer etc...any suggestions on what i might expect It also sticks in either forward or reverse which obviously is dangerous on close up work. Thanks for any advice...

 

[mobilus]

Take a close look at the roller and the cam it rides in...the cam becomes wallowed out, and doesn't center anymore. On my L2800 (which should be close), I experienced the same thing. Cheap enough fix. Two bolts on the cam, snap ring holding the roller.

 

[Thomas]

As mobilus wrote also check for debris.

 

[gravelman]

Ok im not much of a mechanic but i will take a looksee...THANKS VERY MUCH

 

[RNeumann]

Not a Kubota guy, but on my machine the springs are exposed and just under to floorboard. Hope it’s an easy reattachment if a spring or something similar.

 

[RalphVa]

On my JD 4010, one of the hydro pedals lost a pin that kept it from returning.

Ralph

 

[gravelman]

Ok guys...thanks much..i will look at it closely tomorrow...and report back...THANKS ALOT...