Modemman
New member
What is the easiest and cheapist way to add an extra set of couplers on a Duetz Allis tractor?
hydraulics
- Thread starter Modemman
- Start date
- Views: 1099
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,973
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Tell us what you have for hydraulics.
it has one pair of couplers already, but to run a round baler, i need two pair.
i have another tractor to bale with, but wanted to have both in case something happen to the other, i could bale with the other.
I have seen valves to put into the existing one, and uses electric switch to use two at a time, but it is kinda expensive to me. Any help would be appreciated, JJ. Thanks
i have another tractor to bale with, but wanted to have both in case something happen to the other, i could bale with the other.
I have seen valves to put into the existing one, and uses electric switch to use two at a time, but it is kinda expensive to me. Any help would be appreciated, JJ. Thanks
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,973
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
If your valve is a mono block valve you will have to add another valve in series.
If it is a stacked valve, you can add to the stack.
A selector/diverter valve will take one input and provide two outputs. Use a switch to switch between which cyl or motor.
If it is a stacked valve, you can add to the stack.
A selector/diverter valve will take one input and provide two outputs. Use a switch to switch between which cyl or motor.
Last edited:
Leejohn
Elite Member
Did it come new with the one you have now or was it added later? Might be able to just get a 2 or 3 spool valve and replace the old one.
