Hydraulic Top and Tilt help

[Haydro]

Greetings.

I own a LS MT3 42. I am looking to purchase a Hydraulic Top link and a Hydraulic Side link.

I am running in circles, so I am looking for help and guidance.

Cat 1 Top Link:
1. Pin hole sizes: 3/4"
2. Length of mechanical top link: 16.9 - 25.7 in

Side Link:
1. Fork ends both sides
2. Pin hole sizes: Top is 3/4", bottom is 5/8"
3. Length of mechanical side link: 17.7 - 22.2 in

I have valve type couplers.

Any help would be greatly appreciated.

 

[m5guy]

I have a 3 57, I bought my hydro top link on eBay, cat 1. Never thought about the side link....

 

[/pine]

Top links are fairly generic as long as the extended/retracted measurements work...
...Side links are usually a different story...look at the static side link and see if the angles of the forks (where they attach) are the same...usually they are different top and bottom...
A lot of guys that make their own side links cut the ends off their OEM static side link and weld them on a cylinder...

 

[MtnViewRanch]

Greetings.

I own a LS MT3 42. I am looking to purchase a Hydraulic Top link and a Hydraulic Side link.

I am running in circles, so I am looking for help and guidance.

Cat 1 Top Link:
1. Pin hole sizes: 3/4"
2. Length of mechanical top link: 16.9 - 25.7 in

Side Link:
1. Fork ends both sides
2. Pin hole sizes: Top is 3/4", bottom is 5/8"
3. Length of mechanical side link: 17.7 - 22.2 in

I have valve type couplers.

Any help would be greatly appreciated.

With the LS side link, you will not be looking for the complete unit as you have pictured, just the part that is below the lower pivot point as I have pictured.
I don't think that you will find a hydraulic top link to match what your manual top link is.
I recommend that you look at the following link, get the asked for pin-pin distance and get a hydraulic top link that has that asked for dimension as the mid stroke or as close as you can find.

Here is that link. Top link