Hydraulic noise on L3710

   / Hydraulic noise on L3710 #1  

PAFarmBoy

New member
Joined
Jan 17, 2005
Messages
3
Location
Pennsylvania
Tractor
Kubota L 3710
When I fully raise my rear blade on my tractor, it sounds like the engine is straining. If I then lower the blade a very small amount, the engine returns to normal.

Any thoughts/suggestions would be appreciated!

/forums/images/graemlins/confused.gif
 
   / Hydraulic noise on L3710 #2  
Linkage that controls the hydraulics needs to be adjusted to stop trying to raise 3PH when it is at end of it's up stroke. There is a thread that I could not find on how to make this adjustment on a B2910. I'm not sure if the L3710 is the same.
Until you get the adjustment made make sure you keep the 3PH a little below full up. Hydraulic oil will over heat and cause damage to hydraulic system if kept in position you describe.
 
   / Hydraulic noise on L3710
  • Thread Starter
#3  
Thanks very much for the update !
 

Tractor & Equipment Auctions

2018 Infiniti QX60 Multipurpose Vehicle (A51694)
2018 Infiniti QX60...
Redirective Crash Cushion Guardrail (A51692)
Redirective Crash...
NEW Mini Excavator Fixed Thumb Attachment (A53002)
NEW Mini Excavator...
2012 Ford Fusion SE Sedan (A50324)
2012 Ford Fusion...
1982 GOOSENECK 24FT TRAILER (A52472)
1982 GOOSENECK...
2009 Lexus RX 350 SUV (A50324)
2009 Lexus RX 350...
 
Top