How to hook up a woods backhoe to a CK20???????

   / How to hook up a woods backhoe to a CK20??????? #1  

Slackdaddy

Gold Member
Joined
Mar 31, 2007
Messages
324
Location
Land of the Free
Tractor
Kioti CK20HST
I have a CK20 and a woods 7500 backhoe,, biggest mistake (Woods)
Anyhow,, I for the life of me can not figure out how to hook the dam backhoe to the tractor.
Tractor has the woods sub frame kit.

The 3 point arms are right in the way,, and as usual, the woods instructions are no better the something from China.

Many thanks to anyone that can help out,

Slack
 
   / How to hook up a woods backhoe to a CK20??????? #2  
I think you take the 3 point hitch arms off
 
   / How to hook up a woods backhoe to a CK20??????? #3  
I had a Woods hoe on my CK-27 and really liked it. I always took off the 3 pt. arms and left the hoe on for ballast unless I was using the 3 pt.
 
   / How to hook up a woods backhoe to a CK20??????? #4  
I have a CK20 and a woods 7500 backhoe,, biggest mistake (Woods)
Anyhow,, I for the life of me can not figure out how to hook the dam backhoe to the tractor.
Tractor has the woods sub frame kit.

The 3 point arms are right in the way,, and as usual, the woods instructions are no better the something from China.

Many thanks to anyone that can help out,

Slack

I have a 2003 CK20h, at that time the "factory" backhoe was supplied by Rhino. It's a 6.5 ft uses the subframe and mine has the PTO hydraulic pump and tank.(highly recommend, I can out dig a tractor beyond hydraulic at 1/4 throttle)
You MUST remove 3pt hitch arms. The hoe mounts under center by sliding a cross bar into 2 notches, the rear mounts into a notch under draw bar and whole thing is held in place by 2 3/4" pins. T probably have over 500hrs on hoe with no problems. Hope that helps. Joe48
 
   / How to hook up a woods backhoe to a CK20??????? #5  
I had a CK30 with the Kioti backhoe and subframe. There was no need to remove 3pt arms to install this BH. I now have a DK40 with the Woods BH, with the Woods BH I need to remove the 3pt arms to get them out of the way before I can put the Woods BH on. It is only 2 bolts and 4 pins to remove the arms, takes less than 5 min.
 

Tractor & Equipment Auctions

Pallet of Lights (A53117)
Pallet of Lights...
Ingersoll-Rand Winch (A53117)
Ingersoll-Rand...
2-Pallets Air / Discharge Hose (A53117)
2-Pallets Air /...
Adams 5 ton Fertilizer Buggy / Wagon (A53473)
Adams 5 ton...
2018 HINO CONVENTIONAL TYPE TRUCK (A52472)
2018 HINO...
2016 Peterbilt 567 Tri-Axle Dump Truck (A51692)
2016 Peterbilt 567...
 
Top