I have a CK25HST and the shroud surrounding the 3-pt height adjustment lever broke where the little stop adjustment was. I ordered the shroud and I am ready to replace it but the problem is that the plastic handle on the lever needs to be removed. It appears to have been pressed on while hot. How do you remove this handle?
How do you remove a plastic handle?
- Thread starter yoyo
- Start date
- Views: 1107
jimmyj
Elite Member
- Joined
- Aug 28, 2007
- Messages
- 4,126
- Location
- Ontario Canada
- Tractor
- Allis Chalmers 616 (Two) and a Kioti CK30 HST with loader and backhoe
You should be able to just pull it up and off.
SSdoxie
Elite Member
It pulls off, but you may need to break the vacuum under it as it pulls off. Either work a thin screwdriver or similar up along one side to allow air in as it comes up or drill a pin hole in the top so air can enter.
