How do you clean your greasy loader pivots?

[grsthegreat]

I put even less grease in my zerks. I used to pump until it comes out, but since i keep it greased anyways, i dont overdo it. I simply give a few squirts to each point and be done with it.

In over 30 years of tractor ownership i have not damaged a pivot point yet.

If i was doing this commercially, id use electric grease gun and let it fly. Would not care less. But mine isnt used hard.

 

[MinnesotaEric]

I put even less grease in my zerks. I used to pump until it comes out, but since i keep it greased anyways, i dont overdo it. I simply give a few squirts to each point and be done with it.

In over 30 years of tractor ownership i have not damaged a pivot point yet.

If i was doing this commercially, id use electric grease gun and let it fly. Would not care less. But mine isnt used hard.

IMO electric grease guns stink because you're still using those lousy 20oz tubes of grease. Either a bulk air-driven grease gun or a G-gun is the way to go.