SkylineAcres16
Member
I have a #40 chain that I am assembling and this is the masterlink I received. I am wondering the proper way to bend that little wire? I don't want to have problems in the future. I have never seen this type. Thanks!
How Do I Install This Chain Masterlink?
- Thread starter SkylineAcres16
- Start date
- Views: 812
i7win7
Veteran Member
That is a half link most use a cotter pin like this one
Amazon.com : GasBike #415 Half Link (Half Locks) : Sports & Outdoors
I would bend into an S shape
Amazon.com : GasBike #415 Half Link (Half Locks) : Sports & Outdoors
I would bend into an S shape
kthompson
Elite Member
- Joined
- Sep 12, 2008
- Messages
- 3,509
- Location
- South Carolina
- Tractor
- Kubotas B2710, M6800, L6060 cab, Volvo EC excavator, 2 ZTRs and various implements.
From the single view you have not sure how you bend it. But based upon the single view does not the other pin come into the top part also? If so does it have a hole for the clip to run through?
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,143
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
That is an offset link also known as a half link. A master link or connector link would have straight side straps.
To answer your question, bend the wire in an S shape with both ends as close to the side strap as possible.
To answer your question, bend the wire in an S shape with both ends as close to the side strap as possible.