I found there were several people that had questions about replacing a hot wire indicator for their glow plugs and thought I would try to help. . It is called Nichrome (Nickel Chromium) wire and its been around since 1906. It was the first wire used for resistance heating elements. It is relatively inexpensive and will withstand tens of thousands of heating cycles. I used to make replacement heating elements for antique heaters. You can measure the diameter and length and order it from McMaster Carr online. Sizes from .003" to .081" Dia.($30/6'). They sell retail to anyone and are the World's largest hardware supplier. If you need larger than .081" Dia. you'll have to look elsewhere or shorten the length to lower the resistance without getting it so short it glows like a headlight 
.. You want the indicator wire to glow red to bright orange, but not yellow or white hot. Glow plug voltage varies by the engine brand, they can be 1.5 volts up to 24 volts on some engines. You can take them all out (and test their resistance from terminal to body ground to make sure they are good), and hook them all up to a battery with the resistance wire, then adjust length to keep the plugs a dull red color after a 10 second test.. If you coil the wire, the coil loops MUST NOT touch each other. I have made ceramic insulator rings by using a Dremel cut-off wheel (and dust mask) from old knob & tube wiring from an old electrician I know.
Feel free to ask questions, or correct me. Although I am a Master Electrician, I am only an amateur Diesel Mechanic.
.. You want the indicator wire to glow red to bright orange, but not yellow or white hot. Glow plug voltage varies by the engine brand, they can be 1.5 volts up to 24 volts on some engines. You can take them all out (and test their resistance from terminal to body ground to make sure they are good), and hook them all up to a battery with the resistance wire, then adjust length to keep the plugs a dull red color after a 10 second test.. If you coil the wire, the coil loops MUST NOT touch each other. I have made ceramic insulator rings by using a Dremel cut-off wheel (and dust mask) from old knob & tube wiring from an old electrician I know.Feel free to ask questions, or correct me. Although I am a Master Electrician, I am only an amateur Diesel Mechanic.
