racerboy832
Silver Member
Some reason I thought that clips onto shaft on both sides. Kinda like where it's hook on it already it clips on the other side too.
Hinomoto E324 clutch
- Thread starter iloveketchup
- Start date
- Views: 23626
OP
iloveketchup
Member
- Joined
- May 6, 2011
- Messages
- 47
- Tractor
- Hinomoto E324
It's a mirror image on the other side. There is 2 clips, one not shown.
OP
iloveketchup
Member
- Joined
- May 6, 2011
- Messages
- 47
- Tractor
- Hinomoto E324
tractor is all together.
turned over with clutch engaged, tractor crept (good)
adjusted clutch, pressed clutch, turned over engine, tractor remained still
Thing is... can't get it started.
I did disconnect fuel lines so... could there be air in the line or ??? I'm not too familiar with diesels. I only disconnected the fuel line, i never cranked it while
turned over with clutch engaged, tractor crept (good)
adjusted clutch, pressed clutch, turned over engine, tractor remained still
Thing is... can't get it started.
I did disconnect fuel lines so... could there be air in the line or ??? I'm not too familiar with diesels. I only disconnected the fuel line, i never cranked it while
Hinomotoman
Gold Member
- Joined
- Jul 9, 2009
- Messages
- 258
- Location
- Western NC
- Tractor
- LS R3039, Hinomoto E2604, Hinomoto N239, Case IH 1140, White Field Boss 31
So which clutch did you end up using? I've always wanted a 324. Super tough looking tractor. I almost bought 2 but the deals fell through.
Eugene
Eugene
OP
iloveketchup
Member
- Joined
- May 6, 2011
- Messages
- 47
- Tractor
- Hinomoto E324
I used the MF1233's clutch parts (disc, plate, release bearing). The pilot bearing was a 6203DU (common design). I don't know if the release bearing is the same as the MF1233 or not.
Personally I liked my Kubota more and will probably try and find something else. Maybe find a Case 580CK? The hydraulics on either the E324 are weak by design (possibly low flow rates?) or this one's are a little weak. They work, but weak. I don't really see how this thing could actually be putting out 40 HP either although advertised as such. If i could get the right price for it, i'll probably sell and find another something to play with.
SkyPirate
New member
the hydraulics on my E324D work great,..if I m not careful using the bucket I will pick the back of the tractor up off the ground with a 6 foot box blade attached if I have too much in the loader bucket
I noticed in one of your photo's you have a mechanical "clutch out" or disengage lever,..use it
mine doesnt have one and I think the disc is rusted to the flywheel or pressure plate,..can't disengage it
I noticed in one of your photo's you have a mechanical "clutch out" or disengage lever,..use it
mine doesnt have one and I think the disc is rusted to the flywheel or pressure plate,..can't disengage it
