Ran a new bush hog with no oil in the gearbox and of course it locked up. Ordered a new gearbox and a couple guys in our shop swapped it out. For some reason they disassembled the motor, not sure why. Now it spins in the wrong direction at full torque and it will spin but has no power in the right direction. They have no idea what they may have changed. Can someone help me?
Help, replace gearbox on skid loader bushhog now it runs backwards.
- Thread starter Boof621
- Start date
- Views: 5554
2 hoses.
ROUSTABOUT
Elite Member
- Joined
- Jan 30, 2008
- Messages
- 3,140
- Location
- Luther Willis Hill, AR
- Tractor
- Pettibone, Ford, Massey Ferguson, International, JD, David Bradley, home mades
Maybe swap hoses. Maybe they swapped hoses.
Hay Dude
Super Star Member
- Joined
- Aug 28, 2012
- Messages
- 19,116
- Location
- A Hay Field along the PA/DE border
- Tractor
- Challenger MT655E, Massey Ferguson 7495, Challenger MT535B, Krone 4x4 XC baler, (2) Kubota ZD331’s, 2020 Ram 5500 Cummins 4x4, IH 7500 4x4 dump truck, Kaufman 35’ tandem 19 ton trailer, Deere CX-15, Pottinger Hay mowers
Is this on a skiddy out front? Or a rear mount?
seville009
Veteran Member
- Joined
- Oct 22, 2007
- Messages
- 1,569
Agree with Roustabout above.....try swapping the hoses. If the connections are different, might have to swap the connections on the mower side.
dirttoys
Platinum Member
Yup, that was my question about hi-flow or not. Swap the quick connects on the implement side and see what happens.
Best,
ed
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,905
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
My brush hog cuts rotating either direction. The the blades are sharpened on both edges. I thought all skid steer brush hogs were made this way.
LD1
Epic Contributor
You hooked the hoses up backwards. No big deal, just swap them
Swapped hoses and all it does is operate the opposite direction same symptoms. This one is single direction. The blades are only sharp on one side. I think it is a check valve at the motor that was reassembled wrong. This is a standard duty front mount hydraulic bush hog. Any other suggestions?