HELP L4060 wont start

[SandraOpines]

L4060 ran fine yesterday, went out to start it today and nothing.

No starting, cranking nothing.

Battery seems fine, jump start made no difference.
PTO switch is off
OPS seems fine

All cab fuses are good.

4 larges fuses under the hood are fine.

No codes, all dash lights and indicators normal.

HST pedal is in neutral.

What am I missing??

Hate to call dealer if its something simple.

Thanks in advance!

 

[Fallon]

Does the dash turn on? If not computer or electrical supply.

I haven't checked in a while but I'm pretty sure the dish complains about safety sensors (pto, pedal, etc) being tripped.

If the dash is fine & working, probably loose wiring to the starter relay or a bad relay.

 

[SandraOpines]

Does the dash turn on? If not computer or electrical supply.

I haven't checked in a while but I'm pretty sure the dish complains about safety sensors (pto, pedal, etc) being tripped.

If the dash is fine & working, probably loose wiring to the starter relay or a bad relay.

Dash turns on. Will check the wiring to the starter relay.

Thanks so much

 

[seville009]

on my MF 1540 HST, the range selector has to be in neutral to start. It was out of kilter this past summer (loose nut), so even though it was in the neutral position per the indicator, it really wasn’t. Zi would have to move it around a bit to find neutral and be sble to start.

Not sure if you have the same lever on your tractor.

 

[Roadworthy]

At the risk of offering a stupidly obvious suggestion, did you depress the clutch?

 

[buck12]

Operator presence sensor?

 

[Peter 315]

You try rocking the hst pedal......

 

[RjCorazza]

The seat switch will not prevent the tractor from starting unless the PTO or HST switches are active. The dash will report that either the PTO or HST controls need to be off or in neutral once the key is turned to the crank position.

 

[SandraOpines]

FIXED: Thank you!

It was the wiring to the starter relay connection. We are doing Hurricane Michael cleanup which is just untold debris and somehow the starter relay connection became unplugged. Plugged it back in and voila.

Thank you so much!!!!!!!!!!!!

 

[pokey1416]

FIXED: Thank you!

It was the wiring to the starter relay connection. We are doing Hurricane Michael cleanup which is just untold debris and somehow the starter relay connection became unplugged. Plugged it back in and voila.

Thank you so much!!!!!!!!!!!!

Where is that plug? Something us L4060 should be checking do you think?