Help John Deere 320 Kawasaki Engine Won't turn over

   / Help John Deere 320 Kawasaki Engine Won't turn over #11  
That fixed it! Thanks everyone. Now to figure out why the oil filter seams to leak oil.

Not tight enough, or too tight. :)

Or the seal is messed up, or has dirt under it. Not much else to go wrong, as long as there isn't a hole in it.

Glad the cable connections are ok now, and you are back in business. Looks like a good snow clearin rig.
 
   / Help John Deere 320 Kawasaki Engine Won't turn over #12  
..... Now to figure out why the oil filter seams to leak oil.

Just had this happen on my '08 GMC pickup truck. Replaced the filter and all is fine now. I've also seen where the rubber seal from the old filter stuck to the engine and new filter was put on over the old seal causing leak.
 
   / Help John Deere 320 Kawasaki Engine Won't turn over #13  
That fixed it! Thanks everyone. Now to figure out why the oil filter seams to leak oil.

Did you lube the gasket on the new filter with clean engine oil before installing? If not, possible that the gasket bulged up a bit when filter was tightened.
 
   / Help John Deere 320 Kawasaki Engine Won't turn over
  • Thread Starter
#14  
Not the oil filter. I posted a question for help. This little gadget is where the leak is occuring
4378996170_81dd64e699.jpg
 
   / Help John Deere 320 Kawasaki Engine Won't turn over #15  
Not the oil filter. I posted a question for help. This little gadget is where the leak is occuring

Oil pressure sensing unit? Maybe just needs tightened.
 

Tractor & Equipment Auctions

2013 INTERNATIONAL MA065 CAB AND CHASSIS (A52472)
2013 INTERNATIONAL...
1995 Well-Craft 210 SS Elcipse Boat (A50515)
1995 Well-Craft...
2020 Kubota Z723KH 48in. Zero Turn Commercial Mower (A50322)
2020 Kubota Z723KH...
Case Ih 1660 Combine (A50514)
Case Ih 1660...
2020 VOLVO VNL64T740 TANDEM AXLE MID ROOF (A52141)
2020 VOLVO...
Hydraulic Grapple Bucket (A47384)
Hydraulic Grapple...
 
Top