Vilkas
New member
I recently purchased a Grillo G107 plus a few attachments site unseen. The price was good enough that repairs/ a few parts are not too much of a concern,...I think. Well, got the engine running, tiller attachment working, dozer blade cleaned up a painted, and a little flail mower maintenance. One last problem, the clutch does not disengage.
It runs forward and backward, as well as all gears. But, I have to "pop" it into gear as the clutch does nothing (obviously it is not in full service yet as I do not want to create more damage). That is it moves whether pulled up or released; no difference. I adjusted the cable to the proper slack as well as tightening it up quite a bit. No luck.
I spoke to earthtools about it and they suggested the cable adjustment (as mentioned above). I was wondering if anyone else has come across this problem on a Grillo (found a similar thread regarding a BCS). I plan on calling ET again tomorrow as well as pulling the engine and taking a look this weekend.
If anyone can share their insights, it would be much appreciated.
**now posted in 2-wheel tractor**
It runs forward and backward, as well as all gears. But, I have to "pop" it into gear as the clutch does nothing (obviously it is not in full service yet as I do not want to create more damage). That is it moves whether pulled up or released; no difference. I adjusted the cable to the proper slack as well as tightening it up quite a bit. No luck.
I spoke to earthtools about it and they suggested the cable adjustment (as mentioned above). I was wondering if anyone else has come across this problem on a Grillo (found a similar thread regarding a BCS). I plan on calling ET again tomorrow as well as pulling the engine and taking a look this weekend.
If anyone can share their insights, it would be much appreciated.
**now posted in 2-wheel tractor**
Last edited:
