Grill Guard

[oosik]

I had the same thing done to mine. Fortunately - before - any damage.View attachment 405488

 

[AaronS]

Great job George.

 

[GFarmer13]

Looks really good. I hope to do that for mine one of these days.

Could you take a picture of the D rings on the side of the frame? I have been trying to come up with something to bolt to those four holes for tie down. Is that what you use them for?

 

[George2615]

Looks really good. I hope to do that for mine one of these days.

Could you take a picture of the D rings on the side of the frame? I have been trying to come up with something to bolt to those four holes for tie down. Is that what you use them for?

I drilled the brush guard and mounted the D-rings for tie down points. There are 4 holes on each side of the frame but they won't line up with the D-rings mount holes unless you elongate the holes. the brush guard is plenty strong and is bolted to the frame with 4 grade 10.9 metrics.

 

[Bluesteel]

Very nice George.

 

[gphil12873]

Yes that is a nice job. Can tell you took your time and did a good job. I bet it was fun bending the edges over but to me it looks better the way you did it.

 

[George2615]

Yes that is a nice job. Can tell you took your time and did a good job. I bet it was fun bending the edges over but to me it looks better the way you did it.

As mentioned in post 4 it was hard to bend that thick mesh but it was worth it in the end for a clean look. Here's a couple pics of it back on the tractor.

 

[lostcreekranch]

As mentioned in post 4 it was hard to bend that thick mesh but it was worth it in the end for a clean look. Here's a couple pics of it back on the tractor.

George;

Did you use the "Sail Blue" paint. Look like a good match.

Hope to get mine done this weekend.

Sent from my iPad using TractorByNet

 

[ozley]

As mentioned in post 4 it was hard to bend that thick mesh but it was worth it in the end for a clean look. Here's a couple pics of it back on the tractor.

hey nice job looks strong. May I ask you what is that bolt with big washer in the middle of the loader support tube next to the front hydro lines.
Thanks

 

[George2615]

George;

Did you use the "Sail Blue" paint. Look like a good match.

Hope to get mine done this weekend.

Sent from my iPad using TractorByNet

Yes I did use Sail Blue Rustoleum. Not exact but close enough.