Good morning!!!!

[rswyan]

Thanks for the heads-up, RNG. I have two sets of those. Guess I need to check the part numbers when I get home.

2x ... on all counts ... :thumbsup:

 

[rswyan]

RS, any recent pics of the tank room? Last pic I remember seeing was when you were still setting it up. I am being too lazy to try and search for them ....

Nope.

 

[toppop52]

Got the grass mowed, now time to pop the bucket on and get to work.
Supposed to rain tomorrow and Saturday. I’ll try to remember to take pics as I go along.
Made it to the mid sixties, clouds and sun. At least the wind is tolerable today.

 

[sodamo]

67° and .63 inches rain. Nice to see sun this morning.

Trip to PO this morning then back to the canopy project. Hoping for 2 coats paint on the frame. Get the Ezgo top cleaned up, primed and painted.

I can see the grass will be calling my name especially if we get significant sun today.

Prayers for all
Be safe
Have a great day

 

[RedNeckGeek]

RNG, better to break something on the tractor than your neck, I'd say go for the widest wheel setting possible unless you intend to plant a vineyard.

No vineyards here, Eric, and with my black thumbs, there's not likely to be anytime soon. Lots of rocks and poison oak, though.

Oddly, the wheels on the M62 only mount one way, so there's no adjusting the track width. But Kubota did choose to mount the rear wheels with the dish facing out, so that they would create the widest track possible.

 

[Buppies]

Mostly nice large mouth

 

[txdon]

RNG, the tooth bar goes in front of the bolt on edge and attaches to holes drilled into side. It is true the bolt on edge is protected by the tooth bar and you will never need to replace it. That is the same type of upgraded heavy duty bucket I had on the Kubota L5030. The top of the bolts are in-between the teeth and the bolt measurement is needed so the teeth do not interfere with the bolts.

My bar was actually behind the bolt on edge. (only pic I could find)

 

[txdon]

Ran across this, blast from the past:

 

[wngsprd]

RNG, thanks from me, too, on the recall. I have those 6 ton ones...always thought they were too easy to release.

Buppies, sounds really bad...been hearing about the dam and flood on our local news.

 

[rswyan]

RNG, the tooth bar goes in front of the bolt on edge and attaches to holes drilled into side. It is true the bolt on edge is protected by the tooth bar and you will never need to replace it. That is the same type of upgraded heavy duty bucket I had on the Kubota L5030. The top of the bolts are in-between the teeth and the bolt measurement is needed so the teeth do not interfere with the bolts.

My bar was actually behind the bolt on edge. (only pic I could find)

Correct ...