lostcreekranch
Super Member
- Joined
- Dec 14, 2012
- Messages
- 7,948
- Location
- Austin County, Texas
- Tractor
- NH TL-100A with Bush Hog 5045 FEL, WR Long 3rd function, LS XR4155HC w/FEL, WR Long 3rd Function.
View attachment 656566
I saw where EA're putting holes into the side of the bucket to attach the tooth bar, Rick, but the edge that's already on there is held by bolts on approximate seven inch centers. Don't think I need those side holes, right?:confused2: So I think all I need is the length, width, and thickness of the edge that's on there, and the bolt spacing so they can get the holes in the right spots.
If it was me .. I'd just remove the existing bar / bolts and install the PTB or EA TB with the two bolts in the sides of your bucket. That would reduce the complication IMHO.