Good morning!!!!

[daugen]

apple crisp in the oven using local apples and half the sugar
the recipe called for.
painting done, dessert made, accomplished something with vaccine.
think I'll quit while I'm ahead
lock in the gains...

 

[daugen]

my friend in Delaware was out running an errand yesterday and came upon this just as it happened.
Someone didn't go through their mental checklist very well when they took off, didn't hook something up.
This ruined someone's day.

 

[RedNeckGeek]

I was once passed by a boat as I rode my motorcycle down the freeway, Drew. I was stuck in rush-hour traffic, and I guess the boat came off the trailer when the driver hit slow traffic and had to stop quickly. Glad I wasn't in the way of the darn thing!:shocked:

 

[buckeyefarmer]

Someone near me overturned a pickup and RV the other day, both upside down.

 

[kenmbz]

When I used to drive 295 in southern NJ, I used to see cars/SUVs flipped every week.
Seems people would see their exit too late and try to make it anyway.
I don't think a week ever went by in the over 2 years I took that route without a flipped vehicle.

In NJ down by where I am, right lane is passing lane :confused2:

 

[PJSprog]

In NJ down by where I am, right lane is passing lane :confused2:

In the St. Louis area, the interstate shoulders are the passing lane ... apparently.

 

[pennwalk]

For the last three days we have been under an air quality alert. Sensitive people are advised not to go out. I don't know what causes this but we have then pretty often. The air looks gray. Yesterday when I went out to get the paper the air smelled like breakfast. I guess the wind was blowing from the Kellogg's plant. That's my kind of pollution.:laughing:

Chris

 

[pennwalk]

I read yesterday that 12,500 people have been vaccinated in Lancaster county. Only 490,000 to go. Hope they find the accelerator pedal soon.

Chris

 

[pennwalk]

Drew, they need to adjust the trim tabs on that thing.:laughing:

Chris

 

[Popgadget]

So there’s at least three of us here with that Eastwood brake. I didn’t make new rods, just drilled and tapped the opposite ends. I put the original
Like you, I also made an insert for the top of the upper die. I like your bottom die, but I’m not that ambitious.

I suspect that my press can exceed the capacity of the brake though.