Glad he wasn't hurt seriously

[RedDawg]

Always concerned when I see these folks cutting by the side of the road on a hillside. Wonder if that blown right rear tire was the cause or a result.

Worker safe after tractor overturns during a mowing job in Lebanon

 

[Dakota_male]

Always concerned when I see these folks cutting by the side of the road on a hillside. Wonder if that blown right rear tire was the cause or a result.

View attachment 758621

Worker safe after tractor overturns during a mowing job in Lebanon

most of us have the pucker factor when tractoring across a the side of a hill,it discouraged us from wanting to do that again.. for a while anyway.

 

[ptsg]

I'm glad the operator is well but what was he expecting really? You just don't do that type of hillside work, specially going sideways with a conventional tractor. Only up and down.

 

[Agvg]

If it has to be a tractor this is a much better solution

 

[MossRoad]

I'm glad the operator is well but what was he expecting really? You just don't do that type of hillside work, specially going sideways with a conventional tractor. Only up and down.

Most of the highway mowing here is done parallel to the highway, and that involves side slopes. It’s extremely common to see mowing crews with large bat-wing mowers on the side slopes. There is no option to go up or down, just across, as there’s usually a ditch or swale at the bottom between the highway and the hill, and 99.9% of the time there’s a fence at the top of the hill. That leaves no place to turn around at the tops or bottoms of the hills. So across they go.

With that said, there are rollovers each year. And you can see the tire marks where they slide down the hills sideways and don’t roll. ROPS, cabs, seat belts.

 

[K5lwq]

Also most of that mowing is contracted out. The guys that are serious about doing it around here will run duals. But a lot of times it is people doing it as a side gig. It is surprising we do not see more roll overs.

 

[ptsg]

Most of the highway mowing here is done parallel to the highway, and that involves side slopes. It’s extremely common to see mowing crews with large bat-wing mowers on the side slopes. There is no option to go up or down, just across, as there’s usually a ditch or swale at the bottom between the highway and the hill, and 99.9% of the time there’s a fence at the top of the hill. That leaves no place to turn around at the tops or bottoms of the hills. So across they go.

With that said, there are rollovers each year. And you can see the tire marks where they slide down the hills sideways and don’t roll. ROPS, cabs, seat belts.

I understand that, I just can't see the point of risking lives and expensive equipment when there plenty of better ways of doing it.

Over here those hillsides are handled with boom flail mowers and the tractors never leave the road. When those can't do it, a crew of 4 to 6 people will do it by hand with gas string trimmers that will also handle the brush around poles, signs, etc that the tractor can't do.

Lately there has been a slight increase on those remote controlled flail mower for the very steep hills though.

 

[kthompson]

I agree with all the comments so far. Never seen one in real life but Ventrac mowers would be a better option, but not as safe as fenced in cows or sheep would be. Yes would cost more but don't build such step grades to begin with.

 

[Thomas]

I know of 2 operators use independent braking when mowing.

 

[hiddentacocatneddih]

ventrac..... to mow 100's of miles of interstate. yeah right.