Front wheel hub removal?
- Thread starter rruss
- Start date
- Views: 3653
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,610
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
I'm assuming here it is a press in type..?? I use a smaller rubber faced, or small dead blow hammer. Strike it lightly with outward strokes, turning it and striking in different spots. Unless there is a lot of paint on it, holding it, it should start to move. Just keep working your way around, and try to get it to come out evenly.
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,610
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
If the cover is too short to strike, I have also used a pair of water pump pliers, to get on the rib on the cap, next to the hub. Just takes some wiggling back and forth, to get it to move.
Hope this helps..!!
Hope this helps..!!
Sorry for not replying sooner - this project hasn't gotten to the top of my stack yet!
The cover doesn't extend out past the hub. It appears to be pressed in, but it's totally withing the cast hub. There are two notches in the hub, where it is shallow enough to try to use a screwdriver to pry, but it won't budge (hence the comments about mangling it). It has a lot of paint on it as well.
I'll stop by the IH dealer to see if new caps are available, and then just get it off by any means necessary
The cover doesn't extend out past the hub. It appears to be pressed in, but it's totally withing the cast hub. There are two notches in the hub, where it is shallow enough to try to use a screwdriver to pry, but it won't budge (hence the comments about mangling it). It has a lot of paint on it as well.
I'll stop by the IH dealer to see if new caps are available, and then just get it off by any means necessary
