Front blade on Jinma 284

   / Front blade on Jinma 284 #14  
Thanks for the compliments. Here's how I did it. I already owned the Meyer plow and bought it new a long time ago. I have no welding equipment so I brought the "A-Frame" from behind the plow to a local weld shop and had them cut off everything I didn't want. Per the photo below I was given the two triangular brackets on each end that are connected to the loader arms. They came from a firm already in the business of making a loader snow blade. Same story for crossover valve. In the photo you can see the brackets with the loader pins but no reinforcing bushings. Next I made a model of plywood and kept adjusting the model until it was right. Then back to the weld shop for prefab and tacking. Then back home and onto the loader for a final check before it became all boxed in.

The angle cylinders run off the front remotes controlled by the valve in the picture. With a lot of help from 3RRL I added these valves, rear remotes, and front remotes.
IMG_1219.jpgIMG_1221.jpgAdded Valves.jpg
 

Attachments

  • IMG_1220.jpg
    IMG_1220.jpg
    297 KB · Views: 177

Tractor & Equipment Auctions

2001 INTERNATIONAL 4700 (INOPERABLE) (A50854)
2001 INTERNATIONAL...
American Sanders Super 7R Electric Wood Floor Edger (A49461)
American Sanders...
2009 Ford F-250 Ext. Cab Knapheide Service Truck (A50323)
2009 Ford F-250...
2023 BANDIT SG-75 STUMP GRINDER (A51242)
2023 BANDIT SG-75...
2015 FREIGHTLINER CASCADIA (A50854)
2015 FREIGHTLINER...
GENERATOR HOUSE POEWERED BY TWIN 550HP (60 SERIES)  DETROIT 14.0L ENGINES (A50854)
GENERATOR HOUSE...
 
Top